Siemens SINUMERIK 840DE sl Commissioning Manual page 1616

Configuration of the system
4.15 Configuring the SITOP UPS module for use with the PCU Base Software
If the HMI software of your OEM installation is not shut down within 180 seconds, you can
parameterize this wait time manually.
Note
Information about the test environment for machine OEMs
The "SITOP UPS" function has been tested in the standard configuration with the PCU base
software. When installing add-on or OEM software components, you must check the shutdown
procedure of the entire system and adapt the factory setting.
Requirement
● The SITOP UPS module is configured for use with the PCU base software.
See Configuring SITOP software V3.x (USB) (Page 54).
● The Service Desktop is active.
58
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
PCU Base Software (IM10)