Xerox Phaser 3330 Service Manual page 91

Troubleshooting
Error Error Message
03-450 Bypass Tray Paper
mismatch
03-600 Memory Failure
03-601 EPC Memory is full
03-602 EPC Memory is
Temporarily Full
03-603 Job to large to fit in
EPC memory
03-800 Check SD Card
2-32 Phaser 3330 and WorkCentre 3335/3345
Service Manual
Cause
Paper Type mismatch.
Paper Size mismatch.
Memory access failure.
Embedded FAX Job
transmit/receive failure.
Print Failure.
Scan to file or Email failure.
Fax Server failure.
Collate Copy Job failure.
Hard drive failure occurred.
Not running properly.
Initial Action
If printing PC, ensure print
driver and tray guide
settings match. Load
requested paper in the
Bypass Tray.
Verify tray guide settings.
Cycle printer power.
Re-seat Memory DIMM(s).
If the error persists install
a new Main Board:
• Phaser 3330 (PL 1.0.7,
Parts List 1.0 Phaser
3330 Main)
• WorkCentre 3335 and
3345 (PL 6.1.7, Parts
List 6.1 WorkCentre
3335/3345 Main).
Try sending again.
Reduce complexity.
Selecting different criteria
for the job
Try sending again.
Wait while memory
resources are made
available to continue
scanning your job. Once
all sheets have been
scanned, touch Close,
reload your originals and
re-scan as many times as
is required to complete
your job. Or touch Cancel
Job to Cancel your job."
Power Off/Power On
If fault persists install a
new hard disk drive.
Xerox Internal Use Only
Go To
Paper
Mismatch
Memory
Failure
Memory
Failure