Importing Horizontal Alignment Data - Horizon Fitness HTS-580 Series Operation Manual

7.6.3 Receiving horizontal alignment
You upload a prepared file of horizontal alignment data from a computer for the
alignment work before setting out.
There are two methods to upload data to the instrument.
1. Directly upload the alignment data to the current operating internal memory
from a computer through a data cable (RS-232).
Refer to 10.8 for the operation method
2. Store the alignment data on an SD card, insert the SD card into the
instrument and then copy data from SD card to the memory.
Refer to 10.9 for the operation procedures.
The horizontal alignment data format is in the following format:
Number Data Format
1 start Z,X,Y,a
2 Line Lz
3 spiral A,Rs,Re
4 arc R,Ly
5 wide Zi,wLi,wRi
6 integer L0
7 peg Zj,wLj,wRj
Meaning of Parameters
Initial Point: Stake number of initial point Z, coordinate X,
coordinate Y, initial azimuth a
Straight line data: the length of straight line Lz
Transition curve data: transition curve parameter A, radius
of initial point Rs, radius of end point Re.
Circular curve data: radius of circular curve R, curve
length Ly.
Widening point data: initiation stake number Zi, width of
left road wLi, width of right road wRi.
Stake Space: the length of stake space is LO
Additional stake point data: additional stake number Zj,
left road width wLj, right road width wRj
95