Slope Setting Out - Horizon Fitness HTS-580 Series Operation Manual

7.6.11 Slope setting-out
Slope setting-out can be performed as part of the Alignment setout option. After
defining the vertical curve and horizontal alignment in the "Define Roads Menu"
it is possible to perform slope setting-out. Press the
will be displayed.
Main screen of SLOPE LAYOUT：
The input cut and fill value ratio is depicted below:
The left and right slopes may be entered for both cut and fill. Enter the required
slopes using positive numbers for both cut and fill. The software selects the
appropriate slope from the table depending on whether the situation is on the left or
right and in cut or fill.
Cutting or filling is determined by the estimated level at the offset of the hinge
point. If the level is above the level of the hinge then the cut slope is used, otherwise
the fill slope is used.
112
F2
1
n
1:n
(SLOPE) key, Slope Setout