3.3 Setting of the Prism Constant
In the factory the prism constant for the total station is set at -30mm. If the
constant of the prism used is not -30mm, you must change this setting. Once the
prism constant is set it will become the new default value until changed.
Procedure
Operation
②
Enter
③
data
Input range:-99. 9mm to +99. 9mm Step length 0. 1mm
*The total station in reflectorless measuring mode sets the prism constant to 0
automatically.
Operation Procedure
Press F3 ( S/A ) Key
in Distance
F3
Measurement Mode
or Coord.
Measurement Mode.
② Press F1 (PRISM)
F1
key
Press F1 (INPUT) key
to enter the Prism
Constant
value. *1, press F4 to
confirm and return to
the Setting Mode.
correction
Display
31