Horizon Fitness HTS-580 Series Operation Manual page 119

③when the NO. of input starting
point of the traverse is the same
to the point NO. of the traverse in
the memory, "input the end point
NO.(The actual
point) and the known point NO."
will be displayed, the No. of the
two points must not be the same.
④after inputting the end point
NO. and the
NO.,press ENTkey
instrument will calculate the
closure difference then,press F3
key to receive the data.
⑤ Now ， instrument dispalys
" ADJUSTMENT COORD? "
pressF4key
coordinate adjustment or press
F3key to escape.
⑥Istrument dispalys ADJUST-
MENT ELEVA? pressF4key to
carry out coordinate adjustment
or press F3key to escape.
If the closure point has been measured:the operation steps are the same to the steps
1,2,3 above
measuring
known point
， the
to carry out
F3
F4
or
F3
F4
or
F3
119