Setting Of The Horizontal Angle; Setting By Holding The Angle - Horizon Fitness HTS-580 Series Operation Manual

4.3 Setting of the Horizontal Angle

4.3.1 Setting by Holding the Angle

Make sure the angle measurement mode is selected.
Operation procedure
①Set the required horizontal
angle using the horizontal
tangent screw
②Press the F2 (HOLD)key
③Collimate the target
④Press the F4 (YES) key to
finish holding the horizontal
angle, the display turns back to
the normal
angle measurement mode
*To return to the previous mode, press the ESC key.
36
Operation
Display
angle
F2
Collimate
F4
Display