Adjusting The Brightness For The 200 Circuit Board Display (Control Panel) - Kodak X-Omat 460 RA Processor Service Manual

Adjusting the Brightness for the 200 Circuit Board Display (Control Panel)

The 200 CIRCUIT BOARD DISPLAY
(CONTROL PANEL) is located on the
side of the processor which is in the
darkroom. Therefore, to prevent
fogging of the film, be sure that the
brightness of the display is no brighter
than is necessary to read the display.
[1] Insert a POTENTIOMETER ALIGNMENT
TOOL through the ACCESS HOLE in the 200
CIRCUIT BOARD COVER and into the
POTENTIOMETER.
[2] Rotate the POTENTIOMETER clockwise to
brighten the display. Rotate the
POTENTIOMETER counterclockwise to dim
the display.
[3] Move the darkroom light switch to the ''OFF''
position.
[4] Adjust the POTENTIOMETER until the
brightness of the display is no brighter than is
necessary for you to read the indicators
shown, yet it is not bright enough to fog film.
6-8
Figure 6-7 Adjusting the Brightness of
the 200 Board Display
POTENTIOMETER
ACCESS HOLE
200 CIRCUIT
BOARD COVER
H108_0160CCB
H108_0160CA
636739