Kodak X-Omat 460 RA Processor Service Manual page 61

[6] Remove the DEVELOPER HEAT EXCHANGER COVER from the bottom of the DEVELOPER TANK.
[7] Loosen the 2 CLAMPS securing the TUBING to the HEAT EXCHANGER. Remove the TUBING.
[8] Remove the 2 NUTS from the DEVELOPER HEAT EXCHANGER. Keep the O-RINGS and WASHERS
for reassembly.
[9] Remove the DEVELOPER HEAT EXCHANGER from the DEVELOPER TANK.
[10] Install the new DEVELOPER HEAT EXCHANGER into the DEVELOPER TANK.
[11] Install all parts removed in previous steps and make the necessary connections.
WASHER
WASHER
O-RING
NUT
CLAMP
TUBING
5-14
Figure 5-12 Removing the Developer Heat Exchanger
DEVELOPER
HEAT EXCHANGER
COVER
DEVELOPER
HEAT EXCHANGER
H108_0147DCA
H108_0147DA
636739