Kodak X-Omat 460 RA Processor Service Manual page 25

[8] Remove the MOTOR and BRACKET
ASSEMBLY from the processor.
[9] Remove the 4 MOTOR BRACKET
MOUNTING SCREWS securing the MOTOR
and GEAR BOX to the BRACKET.
Use caution when removing the
MOTOR so that the MOTOR does not
separate from the GEAR BOX.
[10] Install the new MOTOR and GEAR BOX to
the BRACKET using the 4 MOTOR BRACKET
MOUNTING SCREWS removed previously.
[11] Install all parts removed in previous steps and
make all necessary connections.
[12] Energize the processor by moving the MAIN
CIRCUIT BREAKER, CB1, to the ''I'' position.
[13] Check that all cycle speeds are operating
correctly and not producing any error codes.
[14] Deenergize the processor by moving the
MAIN CIRCUIT BREAKER, CB1, to the ''O''
position.
3-6
NOTE
MAIN
CIRCUIT BREAKER
(CB1)
AUXILIARY CIRCUIT BREAKERS
CB2, CB3, and CB4
Figure 3-4 Energizing and Deenergizing
the Processor
H108_0002CCC
H108_0002CA
636739