Removing The Tank Assembly - Kodak X-Omat 460 RA Processor Service Manual

Removing the Tank Assembly

IMPORTANT
For this procedure the processor must
be deenergized. See page 1-6. In
addition, the TOP COVER, both SIDE
ACCESS PANELS, and the
FEED-END, LOWER ACCESS PANEL
must be removed from the processor.
See pages 1-3 through 1-5 for
instructions, if necessary. Also make
sure that the water supply to the
processor is shut off for this procedure.
[1] Drain the DEVELOPER and FIXER TANKS by
opening the 2 DRAIN VALVES on the FEED
END of the processor.
636739
WASH OVERFLOW
FIXER
and DRAIN
FIXER
DRAIN
AUXILIARY
VALVE
DRAIN
POWER
DEVELOPER
DRAIN VALVE
DEVELOPER
AUXILIARY
DRAIN
Figure 5-13 Opening the Developer
and Fixer Drain Valve
FIXER OVERFLOW
and DRAIN
WATER
INLET
DEVELOPER
OVERFLOW
and DRAIN
H108_0004CCA
H108_0004CA
5-15