Kodak X-Omat 460 RA Processor Service Manual page 81

[4] Disconnect CONNECTOR J29.
[5] Install a JUMPER, TL-4413, into CONNECTOR J29.
[6] Loosen the 2 SCREWS and adjust the DRIVE SIDE SWITCH PLATE ASSEMBLY to the MAXIMUM UP
POSITION to ensure that the SWITCH does not actuate during this adjustment procedure.
[7] Hold the NON-DRIVE SIDE MAGNET SWING ARM to prevent movement.
NON-DRIVE SIDE
MAGNET
SWING
ARM
RESTRAINER
DETECTOR
ROLLER
6-4
NOTE
If necessary, install a RESTRAINER.
Figure 6-3 Adjusting the Switch Plate Assembly
SCREW (2)
SWITCH PLATE
ASSEMBLY
FILM ACCUMULATOR LEDs
REPLENISHMENT PUMPS
H108_0166DCB
H108_0166DA
636739