Kodak X-Omat 460 RA Processor Service Manual page 28

[4] Remove the 2 SCREWS that hold each BEARING SUPPORT.
[5] Remove the CHAIN from the MOTOR SPROCKET.
[6] Remove the MAIN DRIVE SHAFT from the processor.
[7] Remove the COLLAR from each end of the MAIN DRIVE SHAFT.
[8] Remove the 2 BEARING SUPPORTS.
[9] Install 2 BEARING SUPPORTS onto the new MAIN DRIVE SHAFT.
[10] Install all parts removed in previous steps.
[11] Increase the tension of the SPRING by tightening the 2 SCREWS that secure the TENSIONER
BRACKET. Adjust the TENSIONER BRACKET to the minimum tension necessary to turn the ROLLERS.
See Figure 3-6.
BEARING
SUPPORT
636739
SCREWS
DRYER
DRIVE BELT
Figure 3-7 Removing the Main Drive Shaft
MAIN
DRIVE SHAFT
MOTOR SPROCKET
CHAIN
COLLAR
SCREW (2)
BEARING
H108_0083BCA
H108_0083BA
SUPPORT
3-9