Kodak X-Omat 460 RA Processor Service Manual page 84

Final Checkout
Do not place the FILM TOOL under the DETECTOR ROLLERS during the next step.
[15] Check for proper ENTRANCE DETECTOR SWITCH adjustment:
(a) Insert the 43.18 cm (17 in.) end of the FILM TOOL into the ACCUMULATOR.
(b) If the REPLENISHER PUMPS begin operating after approximately 12 seconds, one or both of the
ENTRANCE DETECTOR SWITCHES is not adjusted properly. Repeat Steps 8-15 of the
adjustment procedure.
(c) If the REPLENISHER PUMPS do not begin operating, guide the 4-inch FILM STIP, cut from the
FILM TOOL, into the center of the DETECTOR ROLLERS and allow it to pass through the
processor 3 times. The REPLENISHER PUMPS should begin operating during the third entry.
(d) If the REPLENISHER PUMPS do not begin operating during the third entry, repeat Steps 8-15 of
the adjustment procedure.
[16] Set the processor to the previous cycle.
[17] Remove the JUMPER and connect CONNECTOR J29.
636739
DETECTOR ROLLERS
ENTRANCE DETECTOR SWITCH
Figure 6-6 Guiding the Film Strip into the Detector Rollers
4-inch FILM STRIP
H108_0167BCA
H108_0167BC
6-7