Removing The Developer Heat Exchanger - Kodak X-Omat 460 RA Processor Service Manual

Removing the Developer Heat Exchanger

IMPORTANT
For this procedure the processor must
be deenergized. See page 1-6. In
addition, the TOP COVER and both
SIDE ACCESS PANELS must be
removed from the processor. See
page 1-3 through 1-5 for instructions, if
necessary. Also make sure that the
water supply to the processor is shut
off for this procedure.
[1] Drain the DEVELOPER TANK by opening the
DEVELOPER DRAIN VALVE on the FEED
END of the processor.
5-12
WASH OVERFLOW
FIXER
and DRAIN
FIXER
DRAIN
AUXILIARY
VALVE
DRAIN
POWER
DEVELOPER
DRAIN VALVE
DEVELOPER
AUXILIARY
DRAIN
Figure 5-9 Opening the Drain Valve
FIXER OVERFLOW
and DRAIN
WATER
INLET
DEVELOPER
OVERFLOW
and DRAIN
H108_0004CCA
H108_0004CA
636739