Removing The Blower Impeller Shaft - Kodak X-Omat 460 RA Processor Service Manual

Removing the Blower Impeller Shaft

For this procedure the processor must be deenergized. See page 1-6. In addition, the DRIVE
SIDE ACCESS PANEL must be removed from the processor. See pages 1-3 through 1-5 for
instructions, if necessary.
[1] Remove the BLOWER MOTOR COVER from the BLOWER DRIVE MOTOR.
[2] Remove the BLOWER DRIVE BELT.
[3] Loosen the 2 DRIVE PULLEY SETSCREWS.
[4] Remove the BLOWER DRIVE BELT PULLEY.
[5] Loosen the INNER BEARING SETSCREWS.
[6] Loosen the OUTER BEARING SETSCREWS.
[7] Remove the SCREWS and the HOUSING COVER.
[8] Remove the IMPELLER SHAFT AND IMPELLER ASSEMBLY.
[9] Loosen the IMPELLER SETSCREWS.
[10] Remove the IMPELLER ASSEMBLY from the IMPELLER SHAFT.
[11] Install a new IMPELLER ASSEMBLY onto the IMPELLER SHAFT.
[12] Install all parts removed and tighten any SCREWS loosened in previous steps.
4-4
IMPORTANT
636739