Removing The Quad Power Supply - Kodak X-Omat 460 RA Processor Service Manual

Removing the Quad Power Supply

For this procedure the processor must be deenergized. See page 1-6. In addition, the
FEED-END, LOWER ACCESS PANEL and the RECEIVING-END ACCESS PANEL must be
removed from the processor. See pages 1-3 through 1-5 for instructions, if necessary.
[1] Open the ELECTRICAL BOX COVER.
[2] Disconnect CONNECTORS P/J 110 and P/J 210 from the A1 QUAD POWER SUPPLY.
[3] Remove the 4 SCREWS supporting the A1 QUAD POWER SUPPLY.
[4] Remove the 4 SCREWS from the back of the ELECTRICAL BOX that secure the HEAT SINK.
[5] Remove the A1 QUAD POWER SUPPLY.
[6] Apply HEAT SINK COMPOUND to the back of the HEAT SINK on the new A1 QUAD POWER SUPPLY.
[7] Reverse the above procedure to install a new A1 QUAD POWER SUPPLY.
6-12
Use caution to prevent damage from electrostatic discharge.
IMPORTANT
636739