Removing An Emi Line Filter - Kodak X-Omat 460 RA Processor Service Manual

Removing an EMI Line Filter

For this procedure the processor must be deenergized. See page 1-6. In addition, the
FEED-END, LOWER ACCESS PANEL must be removed from the processor. See pages 1-3
through 1-5 for instructions, if necessary.
[1] Remove the WIRES at the EMI LINE FILTER 1, 2, 3, or 4. See the figure. (EMI LINE FILTER is not
shown.)
Identify line and load labeling so that you can connect the WIRES to the new EMI LINE FILTER
in their correct orientation.
[2] Remove and keep the 4 SCREWS securing the EMI LINE FILTER.
[3] Remove the EMI LINE FILTER.
[4] Reverse the above procedure to install a new EMI LINE FILTER.
EMI LINE FILTER (FL1)
636739
IMPORTANT
NOTE
Figure 6-10 Removing EMI Line Filters
EMI LINE FILTER (FL3)
EMI LINE FILTER (FL4)
H108_0159BCA
H108_0159BA
6-11