Adjusting the Sprocket Alignment on the Main Drive Chain
For this procedure the processor must be deenergized. See page 1-6. In addition, the TOP
COVER and DRIVE SIDE ACCESS PANEL must be removed from the processor. See pages 1-3
through 1-5 for instructions, if necessary.
[1]
Remove the CHAIN GUARD.
[2]
Loosen the SETSCREW on the MOTOR SHAFT SPROCKET.
[3]
Move the MOTOR SHAFT SPROCKET into alignment with the DRIVE SHAFT SPROCKET.
[4]
Tighten the SETSCREW.
Adjusting the Chain Tension
[5]
Loosen the 2 MOTOR MOUNTING BOLTS.
[6]
Move the MOTOR to adjust the MOTOR DRIVE CHAIN for the correct tension, allowing a deflection of
1
1
⁄
in. to ⁄
in. (3.2 to 6.4 mm).
8
4
Lubricating the Chain
[7]
Remove the CHAIN GUARD by loosening the SCREW securing it.
[8]
Check that the MOTOR DRIVE CHAIN is lubricated.
• If the MOTOR DRIVE CHAIN is dry, apply lubricant to the CHAIN. Use NLG1-No. 2 Lithium Ball and
Roller Bearing Grease TL-2324.
• If the MOTOR DRIVE CHAIN is rusty, remove the CHAIN and install a new MOTOR DRIVE CHAIN.
3-2
Do not make the MOTOR DRIVE CHAIN too tight.
Do not allow the DRIVE CHAIN to operate without lubrication.
IMPORTANT
NOTE
636739