Removing The Recirculation Pump - Kodak X-Omat 460 RA Processor Service Manual

Removing the Recirculation Pump

IMPORTANT
For this procedure the processor must
be deenergized. See page 1-6. In
addition, the NON DRIVE SIDE
ACCESS PANEL must be removed
from the processor. See pages 1-3
through 1-5 for instructions, if
necessary.
[1] Disconnect CONNECTOR P/J 7.
[2] Remove the SPLASH GUARD from over the
RECIRCULATION PUMP.
[3] Place a CLAMP, TL-2170, on each of the 4
RECIRCULATION TUBES to prevent leakage
of replenishment solution.
[4] Disconnect each of the 2 RECIRCULATION
TUBES at 2 locations.
[5] Remove the 2 MOUNTING BOLTS.
[6] Remove the RECIRCULATION PUMP.
[7] Install the new RECIRCULATION PUMP.
[8] Install all parts removed in previous steps.
[9] Connect the REPLENISHMENT TUBING.
[10] Connect CONNECTOR P/J 7.
[11] Check that all cycle speeds are operating
correctly and not producing any error codes.
5-2
RECIRCULATION
PUMP
MOUNTING
BOLT (2)
CONNECTOR
J7
Figure 5-1 Removing the Recirculation Pump
SPLASH
GUARD
TUBING
H108_0078CCA
636739