Removing The Dryer Drive Belt - Kodak X-Omat 460 RA Processor Service Manual

Removing the Dryer Drive Belt

For this procedure the processor must be deenergized. See page 1-6. In addition, the TOP
COVER and RECEIVING-END ACCESS PANEL must be removed from the processor. See
pages 1-3 through 1-5 for instructions, if necessary.
[1] Remove the outer AIR TUBES.
[2] Remove the ROLLER ASSEMBLIES.
[3] Remove the inner AIR TUBES.
[4] To release the tension on the BELT, remove the SPRING from the TENSIONER BRACKET by loosening
the 2 SCREWS. See Figure 4-7 on page 4-9.
[5] Remove the DRIVE BELT.
[6] Install a new DRIVE BELT.
[7] Insert the SPRING into the TENSIONER BRACKET. See Figure 4-7 on page 4-9.
[8] Install the inner AIR TUBES, ROLLERS, and outer AIR TUBES.
[9] If the DRYER DRIVE BELT does not remain in the middle of the DRYER IDLER ROLLER, do the Dryer
Belt Tracking Adjustment on page 4-15.
636739
IMPORTANT
DRYER
TRANSPORT
ROLLER
ASSEMBLY
Figure 4-9 Removing Air Tubes and Rollers
PULLEY
SHAFT
H108_0076BCA
H108_0076BA
4-11