Kodak X-Omat 460 RA Processor Service Manual page 96

[6] Open all the DRAIN VALVES on the FEED
END of the processor.
[7] Using a HOSE, thoroughly rinse the inside of
the processor TANKS with water.
[8] Close all the DRAIN VALVES.
[9] Install all the RACKS.
[10] Fill the REPLENISHMENT TANKS with clean
water.
[11] Energize the processor by moving the MAIN
CIRCUIT BREAKER, CB1, to the ''I'' position.
[12] Using the DISPLAY PANEL, select ''Tank
Fill.'' For more instructions about selecting
menu options on the control panel, see the
Operator Manual. The tanks will fill
automatically.
[13] Allow the recirculation and transport cycles to
complete their cycles.
[14] Open all the DRAIN VALVES and drain the
TANKS.
[15] Repeat the previous 3 steps to be sure that
all the System Cleaner is removed.
[16] Deenergize the processor by moving the
MAIN CIRCUIT BREAKER, CB1, to the ''O''
position.
[17] Clean any debris from the DRYER AIR
TUBES and ROLLERS by rinsing them with
warm water.
636739
WASH OVERFLOW
FIXER
FIXER and DRAIN
DRAIN
AUXILIARY
VALVE
DRAIN
POWER
DEVELOPER
DRAIN VALVE
DEVELOPER
AUXILIARY
DRAIN
Figure 7-3 Opening the Developer Drain Valve
FIXER OVERFLOW
and DRAIN
WATER
INLET
DEVELOPER
OVERFLOW
and DRAIN
H108_0004CCA
H108_0004CA
7-5