Kodak X-Omat 460 RA Processor Service Manual page 39

[3] Move the DRYER DRIVE BELT off the DRIVE PULLEY.
[4] Remove the PIN from the DRIVE PULLEY.
[5] Remove the DRIVE PULLEY.
[6] Install a new PULLEY and PIN.
[7] Place the DRYER DRIVE BELT onto the DRIVE PULLEY.
[8] Insert the SPRING into the TENSIONER BRACKET. See Figure 4-7.
[9] Increase the tension of the SPRING by tightening the 2 SCREWS that secure the TENSIONER
BRACKET. Adjust the TENSIONER BRACKET to the minimum tension necessary to turn the ROLLERS.
[10] If the DRYER DRIVE BELT does not remain in the middle of the DRYER IDLER ROLLER, do the Dryer
Belt Tracking Adjustment on page 4-15.
PIN
DRIVE
PULLEY
IDLER ROLLER
4-10
DRYER DRIVE BELT
Figure 4-8 Removing the Pin
SETSCREWS
H108_0071DCB
H108_0071DA
636739