Removing A Dryer Roller Support; Removing The Dryer Heater - Kodak X-Omat 460 RA Processor Service Manual

Removing a Dryer Roller Support

For this procedure the processor must be deenergized. See page 1-6. In addition, the
RECEIVING-END and NON-DRIVE SIDE ACCESS PANELS must be removed from the
processor. See pages 1-3 through 1-5 for instructions, if necessary.
[1] To remove a DRYER ROLLER SUPPORT,
compress the 2 WINGS and push towards
center of the DRYER.
[2] To install a DRYER ROLLER SUPPORT,
snap the ROLLER SUPPORT into the keyed
opening in the SIDE PLATE of the processor's
NON-DRIVE SIDE.
The DRIVE-SIDE SUPPORTS can only
be installed with the opening toward
the BELT. The NON-DRIVE SIDE
SUPPORTS can only be installed with
the opening toward the top of the
processor.

Removing the Dryer Heater

For this procedure the processor must be deenergized, and the RECEIVING-END ACCESS
PANEL must be removed from the processor. See pages 1-3 through 1-6 for instructions, if
necessary.
[1] Remove:
• bottom 6 AIR TUBES
• bottom 12 ROLLERS
• GRILL ASSEMBLY.
[2] Disconnect the WIRES from the HEATER BAR.
4-12
NOTE
IMPORTANT
BACK of
ROLLER SUPPORT
Figure 4-10 Removing a Dryer Roller Support
IMPORTANT
SIDE
PLATE
H108_0081ACA
636739