Danfoss VLT FC 103 Programming Manual page 84

Parameter Description
3.9.7 8-8* FC Port Diagnostics
These parameters are used for monitoring the Bus
communication via the FC Port.
8-80 Bus Message Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of valid
*
telegrams detected on the bus.
8-81 Bus Error Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of telegrams
*
with faults (e.g. CRC fault), detected on the bus.
8-82 Slave Message Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of valid
*
telegrams addressed to the slave, sent by the
frequency converter.
8-83 Slave Error Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of error
*
telegrams, which could not be executed by the
frequency converter.
Range: Function:
0 [0 - 0 ] This parameter shows the number of messages
*
sent from this frequency converter.
Range: Function:
0 [0 - 0 ] This parameter shows the number of messages
*
suppressed due to time-out.
3.9.8 8-9* Bus Jog
8-90 Bus Jog 1 Speed
Range:
100 RPM [ 0 - par. 4-13 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port
or fieldbus option.
8-91 Bus Jog 2 Speed
Range:
Size related [ 0 - par. 4-13
*
RPM]
®
VLT Refrigeration Drive Programming Guide
Function:
Function:
Enter the jog speed. Activate this
fixed jog speed via the serial
port or fieldbus option.
®
MG16H102 - VLT is a registered Danfoss trademark
8-94 Bus Feedback 1
Range: Function:
0 [-200 - Write a feedback to this parameter via the
*
200 ] serial communication port or fieldbus option.
This parameter must be selected in
20-00 Feedback 1 Source, 20-03 Feedback 2
Source or 20-06 Feedback 3 Source as a feedback
source.
8-95 Bus Feedback 2
Range: Function:
0 [-200 - 200 ] See 8-94 Bus Feedback 1 for further details.
*
8-96 Bus Feedback 3
Range: Function:
0 [-200 - 200 ] See 8-94 Bus Feedback 1 for further details.
*
3 3
83