Attach Hand Grips - KidKraft BEAR CAVE LODGE Installation And Operating Instructions Manual

Step 51: Attach Hand Grips
A: Place 1 Hand Grip over the existing holes in (0602) Short Side Trim, making sure that it's centered and flush
to the edges. Pre-drill with a 1/8: (3.2mm) drill bit and attach Hand Grip with 2 (LS2) 1/4 x 2-1/2" Lag Screws
(with flat washers). (fig. 51.1 and 51.2)
B: Repeat step to install a second Hand Grip on the other side.
Fig. 51.1
LS2
1/4 x 2-1/2" Lag Screw
w/ flat washer
X4
centred on face and
flush to edge of Side Trim,
both sides
Hardware
4 x ¼ x 2-1/2" Lag Screws (with flat washers)
LS2
102
Fig. 51.2
0601
per side
1/4" flat
washer
LS2
Steel Hand Grip
LS2
1/4" flat
washer
centred on face and
flush to edge of Side Trim,
Side Trim
both sides
15.9 x 76.2 x 515mm
Short Trim
15.9 x 76.2 x 402mm
Other Parts
2 x Steel Hand Grip