Table of Contents
Advertisement
Use with the Relay 5000/6000/7000/8000 Inserters
The belt stacker can be used in Right Angled or In Line configuration with
the Relay 5000/6000/7000/8000 Inserters.
There are two setups for In Line operation: One for 'letters' (e.g. #10, DL/
C5) sized envelopes, and another for 'flats' (e.g. #9, C4) sized envelopes.
In Line mode is essential for running 'flats'.
Right Angled setup and operation is described below. In Line setup and
operation for letters and flats is described later in this chapter.
Setup of Right Angled mode with Relay System Inserters
The illustration below shows the belt stacker correctly docked to the Relay
system inserter in a right angled orientation.
Follow the steps to correctly set up the stacker:
1. The exit roller bridge (A) should already
have been installed to the Inserter
output.
Make sure the bridge assembly is correctly
located onto its mounting studs.
SV40231 Rev. B
Operation • 2
A
2-1
Advertisement
Table of Contents
