Priming (Prime) - ProMinent DULCOMETER Assembly And Operating Instructions Manual

9.3

Priming (PRIME)

OPERATION
2.20
LIMIT ↓
12.0 °C
Fig. 31: Priming, e.g. to vent a pump
While the continuous display is visible and the states
active, simultaneously pressing
started.
At the same time, dependent on the configuration of the controller, the output relay (P-
REL) is actuated at 100 %, the frequency relay (f-REL) is actuated at
80 % of "PUMPMAX" and 16 mA is output at the mA output. However this is only the
case if these outputs are set as actuator
The power relay (P-REL) starts after priming in an activated state.
You can use this function, for example, to transport the feed chemical up to the pump to
vent the metering line.
STOP
2.20
2.20
0%
12.0 °C
and
Control parameters and functions
2.20
0%
LIMIT ↓
'STOP' or 'OPERATION' are
causes the priming function
'dosing' .
PRIME↑↑↑
2.20 2.20
0%
LIMIT ↓
12.0 °C
'PRIME' to be
A0359
69