Emerson 5301HxxxxxxxxxxxxxxZZ Series Reference Manual page 77

Reference Manual
00809-0100-4530
Verifying probe length
Segmented probe ordered with model code 4S
Before installation, verify the probe length (L) on the label. If the probe length needs to be
adjusted, see
Figure 3-27: Label
A. Probe segments box
B. Probe length
Segmented probe ordered as spare part kit
Before installation, the number of segments that add up to the desired probe length must
be determined. Also, the bottom segment may need to be shortened. See
probe
Assemble the segmented probe
Prerequisites
Note
If there is enough space beside the tank, the probe can be assembled before inserting it
into the tank.
Procedure
1. Insert the stop screw to the top segment. Tighten approximately two turns.
Reference Manual
Adjust the probe
length.
length.
Mechanical installation
April 2019
Adjust the
77