Emerson 5301HxxxxxxxxxxxxxxZZ Series Reference Manual page 45

Reference Manual
00809-0100-4530
Figure 3-18: Shortening of Flexible Twin/Single Lead Probe
A. Spacer
B. Screws
C. Minimum: 1.6 in. (40 mm)
Procedure
1. Mark off the required probe length. Add at least 1.6 in. (40 mm) to the required
2. Loosen the screws.
3. Slide the weight upwards as much as needed in order to cut the probe.
4. Cut the probe. If necessary, remove a spacer to make room for the weight.
5. Slide the weight down to the required cable length.
6. Tighten the screws.
Reference Manual
probe length to be inserted into the weight.
If the weight is removed from the cables, preferably apply electrical tape to the
cables before cutting, in order to avoid the cables to unwind.
Table 3-10: Required Torque and Hex Key Dimensions
Probe
Flexible twin lead
Flexible single lead 4 mm wire, stainless
steel
4 mm wire, Alloy
C-276
4 mm wire, Alloy 400 1.8 ft-lb (2.5 Nm)
4 mm wire, Duplex
2205
6 mm wire
Mechanical installation
Required torque Hex key dimension
4.4 ft-lb (6 Nm) 4 mm
3.7 ft-lb (5 Nm) 4 mm
1.8 ft-lb (2.5 Nm) 3 mm
3 mm
1.8 ft-lb (2.5 Nm) 3 mm
7.4 ft-lb (10 Nm) 5 mm
April 2019
45