Emerson 5301HxxxxxxxxxxxxxxZZ Series Reference Manual page 131

Reference Manual
00809-0100-4530
6. In the Probe window, check configuration of Probe Type. The following Probe Types
7. Check the entered Probe Length. See
8. In the Geometry window, set the tank geometry parameters.
Reference Manual
are available:
• Rigid twin
• Flexible twin
• Coaxial, coaxial HP/C, coaxial HTHP
• Coaxial Large, Coaxial Large HP/C
• Rigid single, rigid single HTHP/HP/C, rigid single PTFE
• Flexible single, flexible single HTHP/HP/C, flexible single PTFE
The transmitter automatically makes some initial calibrations based on the selected
Probe Type. Normally, the Probe Type is pre-configured at the factory.
a) Enter the Tank Height. See
b) Select the Mounting Type.
Probe length for further information.
Tank height for further information.
Configuration
April 2019
131