Removing The Line Filter (Fl1) - Kodak X-Omat M43 PROCESSOR Service Manual

Removing the LINE FILTER (FL1)

Warning
De-energizing the PROCESSOR does not remove the dangerous voltage from the LINE FILTER. Before doing this
procedure, check that the PROCESSOR is disconnected from the main power supply.
Note
See Figure 80 on Page 92 when doing this procedure.
[1] Check that:
• PROCESSOR is de-energized
• main power is disconnected
• TOP COVER is removed
[2] Remove the FEED TRAY by removing:
• 2 SCREWS
• 2 LOCK WASHERS
• 2 WASHERS
Removing the FEED TRAY
Figure 79
[3] Remove the DRAIN VALVE KNOBS by removing the SETSCREWS securing them.
[4] Remove the DRYER TEMPERATURE CONTROL KNOB.
[5] Remove the FRONT ACCESS PANEL by loosening the 2 SCREWS.
[6] Identify and remove the wires at the LINE FILTER.
Important
Identify the line and load labeling so that you can connect the wires to the new LINE FILTER in their correct
orientation.
[7] Remove and keep the 2 NUTS securing the LINE FILTER.
[8] Remove the LINE FILTER.
[9] Install the LINE FILTER by reversing the steps above.
981090 – September 1995
SCREW (2)
LOCK WASHER (2)
WASHER (2)
FEED TRAY
Electrical
H130_0084BCA
H130_0084BA
91