Main Drive; Removing The Drive Motor - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL
Section 4: MAIN DRIVE

Removing the DRIVE MOTOR

Important
Only qualified service personnel should service the PROCESSOR.
Important
All the procedures in this section require that you de-energize the PROCESSOR and remove the TOP COVER before
beginning the first step of the service procedure.
[1] Remove the DRIVE SIDE ACCESS PANEL and the BACK ACCESS PANEL by loosening the 2 SCREWS
on each ACCESS PANEL.
[2] Remove:
• DRYER RACK
• EVAPORATION COVERS
• WASH RACK
• DEVELOPER RACK
• FIXER RACK
[3] If your PROCESSOR has a serial number of less than 350 or does not have Mod 1 installed, cut and remove
the WIRE TIES on the DRIVE MOTOR BRACKET.
[4] Disconnect CONNECTOR P/J1.
Important
Be sure to support the DRIVE MOTOR with your free hand while removing the 2 SCREWS. Continue supporting
the DRIVE MOTOR until you have removed it from the PROCESSOR completely.
[5] Remove the 2 SCREWS, 2 LOCK WASHERS, and 2 WASHERS securing the DRIVE MOTOR BRACKET
to the WASH SUMP TANK.
[6] Remove the DRIVE MOTOR from the DRIVE CHAIN.
[7] Remove the COOLING FAN from the SHAFT.
Removing the DRIVE MOTOR BRACKET
Figure 39
Illustration Shows PROCESSORS With a Serial Number of 350 or less, or Without Mod 1 Installed
50 or 60 Hz
CONNECTORS
P/J1
DRIVE
CHAIN
DRIVE
MOTOR
BRACKET
DRIVE
MOTOR
WIRE
TIE
46
SCREW (2)
LOCK WASHER
(2)
WASHER (2)
COOLING
FAN
Dryer
End
MAIN
DRIVE
SHAFT
SUPPORT
Feed
End
H130_0180BCA
H130_0180BA
September 1995 – 981090