Central Drive Roller Pair Of The Wash Rack; Disassembling A Central Drive Roller Pair Of The Wash Rack - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL

CENTRAL DRIVE ROLLER PAIR of the WASH RACK

Disassembling a CENTRAL DRIVE ROLLER PAIR of the WASH RACK

Note
See Figure 20 on Page 27 when doing this procedure.
[1] Check that:
• PROCESSOR is de-energized
• TOP COVER is removed
[2] Remove the WASH RACK from the PROCESSOR. To prevent contamination of the processing solutions, use
the DRIP TRAY and the SPLASH GUARD (FIXER RACK only).
[3] Remove the EXIT SQUEEGEE ROLLER ASSEMBLY.
[4] Locate the CENTRAL DRIVE ROLLER in need of repair.
[5] From the Non-Drive end of each SHAFT remove:
a. 2 E-RINGS
b. 2 BEARINGS with the SPRING - note the orientation of the TAB on the BEARINGS
• Remove the BEARINGS and the SPRING as an ASSEMBLY. Do not stretch the SPRING over the
BEARINGS.
[6] From the Drive end of the ROLLER, remove the SHOULDER SCREW securing the GEAR at the upper end
of the CHAIN. Remove the GEAR.
[7] Remove the CHAIN from the GEAR on the lower end of the CHAIN.
[8] Install the GEAR and SHOULDER SCREW removed in Step 6 so that the CHAIN hangs freely.
[9] Carefully, slide the SHAFTS out of the ROLLERS.
[10] Only if necessary, remove from Drive end of the SHAFTS:
a. 2 E-RINGS
b. ROLL PIN - use ROLL PIN PUNCH TL-1388
c. GEAR
d. 2 BEARINGS with the SPRING - note the orientation of the TAB on the BEARINGS
• Remove the BEARINGS and the SPRING as an ASSEMBLY. Do not stretch the SPRING over the
BEARINGS.
[11] If necessary, remove the ROLLERS from the WASH RACK. Install new ROLLERS.
26 September 1995 – 981090