Removing The Ac Interlock Switch S5 For The Top Cover - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL

Removing the AC INTERLOCK SWITCH S5 for the TOP COVER

[1] Check that:
• PROCESSOR is de-energized
• main power is disconnected
• TOP COVER is removed
[2] Remove:
• DRYER RACK
• FIXER EVAPORATION COVER
• WASH RACK
[3] Remove the BACK ACCESS PANEL by loosening the 2 SCREWS.
[4] Cut and remove the WIRE TIES securing the INTERLOCK SWITCH BOOT.
[5] Pull the INTERLOCK SWITCH BOOT back to gain access to the CONNECTIONS.
[6] Record the position of the wires on the existing AC INTERLOCK SWITCH S5.
[7] Remove the wires from the AC INTERLOCK SWITCH S5. See Figure 87 on Page 99.
[8] Remove the AC INTERLOCK SWITCH S5 by "snapping" it out.
[9] Install the new AC INTERLOCK SWITCH S5 by pushing it in until it "snaps" into position.
[10] Connect the wires to the AC INTERLOCK SWITCH S5 using the information recorded in Step 6.
[11] Move the INTERLOCK SWITCH BOOT to its original position covering the SWITCH CONNECTIONS.
[12] Install the 2 WIRE TIES. See the figure for the correct locations.
• 1 WIRE TIE P/N 182196
• 1 WIRE TIE P/N 182915
[13] Using the SPRING GAUGE TL-3154, apply 12 lb of pressure on the INTERLOCK SWITCH BOOT.
(a) Check that the BOOT does not slip.
[14] Install:
• all ACCESS PANELS
• all RACKS
[15] Connect the main power and energize the PROCESSOR.
[16] Install the TOP COVER onto the PROCESSOR.
[17] Check that the TOP COVER actuates the newly installed AC INTERLOCK SWITCH S5.
[18] If the DRIVE MOTOR does not energize when you install the TOP COVER onto the PROCESSOR, do the
switch adjustment procedure on Page 98.
Adjusting the AC INTERLOCK SWITCH S5 for the TOP COVER
[19] Loosen the 2 SCREWS on the INTERLOCK SWITCH BRACKET.
[20] Push the MOUNTING BRACKET forward until the BLADE of the TOP COVER fully engages the
INTERLOCK SWITCH. Tighten the 2 SCREWS to secure the BRACKET.
98 September 1995 – 981090