Exit Squeegee Roller Assembly Of The Wash Rack - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL

EXIT SQUEEGEE ROLLER ASSEMBLY of the WASH RACK

WASH RACK Preparation
Note
The SHAFT and ROLLER of the EXIT SQUEEGEE ROLLER ASSEMBLY are a single ASSEMBLY. To replace
the SHAFT and ROLLER ASSEMBLY, you must disassemble both ends of the SHAFT.
[1] Check that:
• PROCESSOR is de-energized
• TOP COVER is removed
[2] Remove the RACK from the PROCESSOR.
[3] Remove the EXIT SQUEEGEE ROLLER ASSEMBLY from the RACK.
Removing the EXIT SQUEEGEE ROLLER ASSEMBLY
Figure 15
Wash
H130_0254BCA
Manifold
H130_0254BA
Disassembling the Non-Drive End of the EXIT SQUEEGEE ROLLER ASSEMBLY of the WASH RACK
[4] Remove from the 2 SHAFTS:
a. 2 E-RINGS
b. 2 SPACERS - 1 SPACER has a TAB, note its location
c. BEARING BLOCK - note the orientation
d. 2 BEARINGS with the SPRING - note the orientation of the TAB on the BEARINGS
• remove the BEARINGS and the SPRING as an ASSEMBLY; to prevent damage to the SPRING, do
not stretch the SPRING over the BEARING BLOCK
e. 2 SPACERS
22
Tab
Upper Wash Tube
September 1995 – 981090