Entrance Roller Pair Of The Developer And Fixer Racks - Kodak X-Omat M43 PROCESSOR Service Manual

ENTRANCE ROLLER PAIR of the DEVELOPER and FIXER RACKS

Note
See Figure 6 on Page 12 when doing this procedure.
[1] Check that:
• PROCESSOR is de-energized
• TOP COVER is removed
[2] Remove the RACK from the PROCESSOR. To prevent contamination of the processing solutions, use the
DRIP TRAY and the SPLASH GUARD (FIXER RACK only).
[3] Rinse the RACK with warm water. Using a clean, damp, lint-free cloth, wipe the ROLLERS to remove any
chemical residue.
[4] From the Drive end of the ENTRANCE DRIVE ROLLER, remove the E-RING closest to the THRUST
BEARING.
[5] Slide the THRUST BEARING and the GEAR towards the Non-Drive end of the SHAFT. The PIN will fall
from the GEAR.
[6] From the Drive end of the ENTRANCE ROLLER PAIR, remove:
a. DRIVE GEAR
b. THRUST BEARING
c. 2 E-RINGS
d. WIRE TIE (FIXER RACK only)
e. BEARING HOLDER with BEARING and SPRING
• remove the BEARING HOLDER, the BEARINGS, and the SPRING as an ASSEMBLY; to prevent
damage to the SPRING, do not stretch the SPRING over the BEARING HOLDER
[7] DEVELOPER RACK Only — From the Non-Drive end of the ENTRANCE DRIVE ROLLER, remove the
END CAP.
[8] From the Non-Drive end of the ENTRANCE ROLLER PAIR, remove:
a. 3 E-RINGS
b. BEARING HOLDER with BEARING and SPRING
• remove the BEARING HOLDER, the BEARINGS, and the SPRING as an ASSEMBLY; to prevent
damage to the SPRING, do not stretch the SPRING over the BEARING HOLDER
[9] Remove the DRIVEN ROLLER.
[10] Using ROLL PIN PUNCH TL-1388, remove the ROLL PIN from the GEAR on the DRIVE ROLLER.
[11] Pull the DRIVE ROLLER SHAFT through the Drive end SIDEPLATE.
[12] Reverse the steps above to assemble the ENTRANCE ROLLER PAIR.
Caution
When assembling the ENTRANCE ROLLER PAIR, check that you:
• position the E-RINGS in the GROOVES on the SHAFTS
• install the BEARING HOLDER, BEARINGS, and SPRING as an assembly to prevent stretching the SPRING
over the BEARING HOLDER
[13] Check that the GEARS of the RACK mesh.
981090 – September 1995
RACKS
11