Exit Roller Pair Of The Developer And Fixer Racks - Kodak X-Omat M43 PROCESSOR Service Manual

EXIT ROLLER PAIR of the DEVELOPER and FIXER RACKS

Note
See Figure 7 on Page 14 when doing this procedure.
[1] Check that:
• PROCESSOR is de-energized
• TOP COVER is removed
[2] Remove the RACK from the PROCESSOR. To prevent contamination of the processing solutions, use the
DRIP TRAY and the SPLASH GUARD (FIXER RACK only).
[3] Rinse the RACK with warm water. Using a clean, damp, lint-free cloth, wipe the ROLLERS to remove any
chemical residue.
[4] From the Drive end of the DRIVE ROLLER, remove the E-RING closest to the THRUST BEARING.
[5] Slide the THRUST BEARING and the GEAR towards the Non-Drive end of the SHAFT. The PIN will fall
from the GEAR.
[6] From the Drive end of the EXIT SQUEEGEE ROLLER PAIR, remove:
a. DRIVE GEAR
b. THRUST BEARING
c. 2 E-RINGS (1 from each SHAFT)
d. WIRE TIE (DEVELOPER RACK only)
e. SPACER (on DRIVE SHAFT)
f. 2 BEARINGS with the SPRING - note the orientation of the BEARINGS
• remove the BEARINGS and the SPRING as an ASSEMBLY; to prevent damage to the SPRING, do
not stretch the SPRING over the BEARINGS
g. 2 E-RINGS against the inner side of the Drive end SIDEPLATE (1 from each SHAFT)
[7] FIXER RACK Only — From the Non-Drive end of the EXIT DRIVE ROLLER, remove the END CAP.
[8] From the Non-Drive end of the EXIT ROLLER PAIR, remove:
a. 2 E-RINGS (1 from each SHAFT)
b. SPACER from the DRIVE SHAFT
c. 2 BEARINGS with the SPRING - note the orientation of the BEARINGS
• remove the BEARINGS and the SPRING as an ASSEMBLY; to prevent damage to the SPRING, do
not stretch the SPRING over the BEARINGS
d. 2 E-RINGS (1 from each SHAFT)
[9] Remove the DRIVEN ROLLER.
[10] Remove the DRIVE ROLLER.
[11] Reverse the steps above to assemble the EXIT ROLLER PAIR.
Caution
When assembling the ENTRANCE ROLLER PAIR, check that you:
• position the E-RINGS in the GROOVES on the SHAFTS
• install the BEARING HOLDER, BEARINGS, and SPRING as an assembly to prevent stretching the SPRING
over the BEARING HOLDER
[12] Check that the GEARS of the RACK mesh.
981090 – September 1995
RACKS
13