Plumbing; Routing The Tubing And Positioning The Screw Clamps - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL
Section 5: Plumbing

Routing the TUBING and Positioning the SCREW CLAMPS

Warning
• DRAINS must be made of chemically resistant, non-corrosive material. Use CPVC or equivalent.
• The DRAIN must have a minimum diameter of 7.6 cm (3 in.) and be free of obstruction.
• DRAIN service must comply with local codes.
Important
Only qualified service personnel should service the PROCESSOR.
Important
All the procedures in this section require that you drain the processing tanks, de-energize the PROCESSOR, and
remove the TOP COVER before beginning the first step of the service procedure.
The correct routing of the TUBING is critical for the correct flow of processing solutions through the PROCESSOR.
Incorrect routing of the TUBING can cause kinks, airlocks, and insufficient draining. See the following figures for
the correct routing.
The correct orientation of the SCREW CLAMPS is essential in order to have access to the SCREWS securing the
SCREW CLAMPS. See the following figures for the correct orientation.
52 September 1995 – 981090