Removing The Developer Thermistor (Rt1) - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL

Removing the DEVELOPER THERMISTOR (RT1)

[1] Check that:
• PROCESSOR is de-energized
• main power is disconnected
• DEVELOPER TANK is drained
• TOP COVER is removed
[2] Remove the FEED TRAY by removing:
• 2 SCREWS
• 2 LOCK WASHERS
• 2 WASHERS
Removing the FEED TRAY
Figure 52
[3] Remove the DRAIN VALVE KNOBS by removing the SETSCREWS securing them.
[4] Remove the DRYER TEMPERATURE CONTROL KNOB.
[5] Remove the FRONT ACCESS PANEL by loosening the 2 SCREWS.
62
SCREW (2)
LOCK WASHER (2)
WASHER (2)
FEED TRAY
September 1995 – 981090
H130_0084BCA
H130_0084BA