Vane Switch - Kodak X-Omat M43 PROCESSOR Service Manual

Removing the DC INTERLOCK SWITCH S6, the DRYER
THERMISTOR, and the AIR VANE SWITCH
Removing the DC INTERLOCK
Figure 34
SWITCH S6, the DRYER THERMISTOR and the
AIR VANE SWITCH
DC INTERLOCK
SWITCH S6
SCREW (2)
DRYER
THERMISTOR
SCREW (2)
981090 – September 1995
DRYER
PLENUM
DRYER
PLENUM
BRACKET
H130_0066CCA
H130_0066CA
[1] Disconnect CONNECTOR P/J28. See Figure 33
on Page 40 for the location of the CONNECTOR.
[2] Remove the 2 SCREWS securing the DC
INTERLOCK SWITCH S6 to the DRYER
PLENUM BRACKET.
[3] Install the new DC INTERLOCK SWITCH S6 to
the DRYER PLENUM BRACKET.
[4] Connect CONNECTOR P/J28.
[5] Disconnect CONNECTOR P/J19. See Figure 33
on Page 40 for the location of the CONNECTOR.
[6] Remove the DRYER THERMISTOR from the
DRYER PLENUM by removing the 2 SCREWS.
[7] Install the new DRYER THERMISTOR.
[8] Connect CONNECTOR P/J19.
[9] Disconnect CONNECTOR P/J26. See Figure 33
on Page 40 for the location of the CONNECTOR.
Caution
Do not remove the AIR VANE SWITCH unless
absolutely necessary. Repeated removal and
installation of the SWITCH may break the
MOUNTING SNAPS requiring the installation of a
new SWITCH.
[10] Remove the AIR VANE SWITCH from the
DRYER PLENUM by releasing the 2 SNAPS on
the MOUNTING BRACKET. See Figure 32 on
Page 39.
[11] Connect CONNECTOR P/J26.
DRYER
41