Removing The Dryer Heater - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL

Removing the DRYER HEATER

Note
See Figure 33 on Page 40 for the location of the CONNECTOR.
[1] Disconnect the CONNECTORS listed below:
• P/J4
• P/J19
• P/J26
• P/J28
[2] Remove the DRYER PLENUM.
[3] Remove the DRYER PLENUM PLATE from the DRYER PLENUM by removing:
• 3 SCREWS
• 3 LOCK WASHERS
[4] Slide the DRYER PLENUM PLATE down to unlock the PLENUM BAFFLE so that you can remove the
DRYER BAFFLE from the DRYER PLENUM.
Removing the DRYER HEATER
Figure 35
LOCK
WASHER
(3)
SCREW (3)
DRYER
PLENUM
PLATE
DRYER
HEATER
[5] Remove the WIRE TIES securing the DRYER HEATER wires.
[6] Remove the 3 SCREWS securing the DRYER HEATER on the DRYER PLENUM PLATE.
[7] Note and record the routing of the wires.
[8] Install a new DRYER HEATER onto the DRYER PLENUM PLATE.
Caution
Do not route the wire near any of the HEATER elements. Check that the wire does not touch the CASE of the
HEATER.
[9] Route the wires as recorded in Step 7. See the figure for the correct routing.
[10] Position the wires in the notch of the DRYER PLENUM. See Figure 35 on Page 42. Use a WIRE TIE to secure
the wires to the DRYER PLENUM PLATE. Use WIRE TIES, as necessary, to secure CONNECTOR P/J4.
[11] Assemble the DRYER PLENUM PLATE into the DRYER PLENUM. Secure the BAFFLE into the PLENUM
PLATE.
(a) Check that the TINE of the BAFFLE correctly engages with the DRYER PLENUM and that it is
perpendicular to the DRYER PLENUM PLATE. See the figure.
42
LOCK
WASHER
(3)
SCREW (3)
notch
H130_0068BCA
H130_0068BA
September 1995 – 981090