Adjusting The Fixer To Developer Replenishment Rate Ratio - Kodak X-Omat M43 PROCESSOR Service Manual
Hide thumbs
Also See for X-Omat M43 PROCESSOR:
- Diagnostics manual (46 pages) ,
- Operator's manual (40 pages)
Table of Contents
Advertisement
SERVICE MANUAL
Adjusting the Fixer To Developer Replenishment Rate Ratio
[1] Check the replenishment rates following the procedure in either the Operator Manual, Publication Number
981089, or the Installation Instructions, Publication Number 981088.
[2] Compare the replenishment rates you obtained to the recommended replenishment rates listed in the
Replenishment Rate Information Sheet, Publication Number 1C5784, located in the front pocket of the
publications binder. If your replenishment rates do not match the recommended rates, adjust the replenishment
rates.
[3] Check that the PROCESSOR is de-energized.
[4] Remove:
• TOP COVER
• DRYER RACK
• WASH RACK
• EVAPORATION COVER
• BACK ACCESS PANEL
Note
The FIXER PUMP is preset for its maximum stroke. Do not adjust the FIXER PUMP. Adjust the DEVELOPER
PUMP CAM until you obtain the replenishment ratio recommended in Publication Number 1C0578.
[5] Rotate the PUMP SHAFT to access the ADJUSTMENT SCREW for the developer.
Adjusting the Developer and Fixer
Figure 50
Replenishment Rate Ratio
REPLENISHMENT
PUMP
increase
decrease
SCREW
60
[6] Rotate the ADJUSTMENT SCREW as necessary.
[7] Connect the main power and energize the
PROCESSOR.
[8] Insert a sheet of film under the MIDDLE FILM
SENSOR to actuate the REPLENISHMENT
PUMP until all air is removed from the
REPLENISHMENT HOSES.
[9] Check the new replenishment rates using the
procedure in either the Operator Manual,
Publication Number 981089, or the Installation
Instructions, Publication Number 981088.
[10] If the replenishment rates are not close to those
listed in Publication Number 1C0578, de-energize
the PROCESSOR and do Steps 6 through 9.
H130_0201ACA
H130_0201AA
[11] Once the replenishment rates are correct:
(a) install all ACCESS PANELS
(b) install the TOP COVER
(c) check for correct replenishment by
• counterclockwise increases the ratio
• clockwise decreases the ratio
processing a sheet of test film
September 1995 – 981090
Advertisement
Table of Contents
