SERVICE MANUAL
ENTRANCE ROLLER ASSEMBLY of the WASH RACK
WASH RACK Preparation
[1] Check that:
• PROCESSOR is de-energized
• TOP COVER is removed
[2] Remove:
• DRYER RACK
• WASH RACK
[3] Remove the ENTRANCE ROLLER ASSEMBLY from the WASH RACK by:
(a) locating the SNAPS on the WASH RACK that secure the ENTRANCE ROLLER ASSEMBLY
(b) pulling the SNAPS away from the BEARING BLOCKS on the ENTRANCE ROLLER ASSEMBLY
Removing the ENTRANCE ROLLER ASSEMBLY
Figure 11
TAB
H130_0254BCB
H130_0254BA
Disassembling the Non-Drive End of the ENTRANCE ROLLER ASSEMBLY of the WASH RACK
[4] Remove from the 2 SHAFTS:
a. 2 E-RINGS
b. 2 SPACERS - note the location of the different size SPACERS
c. BEARING BLOCK - note the orientation
d. 2 BEARINGS with the SPRING - note the orientation of the TAB on the BEARINGS
• remove the BEARINGS and the SPRING as an ASSEMBLY; to prevent damage to the SPRING, do
not stretch the SPRING over the BEARING BLOCK
[5] Slide the ROLLERS off of the SHAFTS.
18
EXIT ROLLER
ASSEMBLY
TAB
ENTRANCE ROLLER
ASSEMBLY
SNAP
September 1995 – 981090