Processors - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL
Removing the DIVERTER VALVE (L2) and (L3) in the M43 and M43A

PROCESSORS

Note
See Figure 59 on Page 71 when doing this procedure.
[1] Check that:
• PROCESSOR is de-energized
• main power is disconnected
• TOP COVER is removed
• WASH TANK is drained
• main water supply is turned off
[2] Remove the NON-DRIVE SIDE ACCESS PANEL by loosening the 2 SCREWS.
[3] Install CLAMPS TL-2170 onto the 3 HOSES to stop the flow of water.
Note
Some water may leak. Be ready to wipe up any spilled water.
[4] Identify the output HOSES (Normal Operation and Cooling Mode).
[5] Remove the 3 CLAMPS securing the 3 HOSES to the VALVE and remove the HOSES.
[6] Remove the SCREW securing the DIVERTER VALVE to the PROCESSOR frame.
[7] Disconnect the 4 WIRE PLUGS from the DIVERTER VALVE.
[8] Record the position of the wires.
[9] Remove the DIVERTER VALVE from the PROCESSOR.
[10] Install the DIVERTER VALVE by reversing the steps above.
[11] Check that the following parts were installed correctly:
• 4 WIRE PLUGS
• 2 output HOSES
• 1 input HOSE
[12] Use the Service Routine to check for the correct operation of the DIVERTER VALVE. See the Diagnostics
Manual, Publication Number 981093.
70 September 1995 – 981090