Removing The Developer Heater (R1) - Kodak X-Omat M43 PROCESSOR Service Manual

Removing the DEVELOPER HEATER (R1)

[1] Check that:
• PROCESSOR is de-energized
• main power is disconnected
• TOP COVER is removed
[2] Check that the DEVELOPER TANK is drained of solution.
[3] Remove the NON-DRIVE SIDE ACCESS PANEL by loosening the 2 SCREWS.
[4] Remove:
• DEVELOPER RACK
• DRYER RACK
• WASH RACK
• EVAPORATION COVER
[5] Remove the BACK ACCESS PANEL in order to gain access to CONNECTOR P/J8.
[6] Disconnect CONNECTOR P/J8.
[7] Remove the 3 SCREWS securing the DEVELOPER HEATER to the inside of the DEVELOPER SUMP
TANK.
[8] Remove and discard the O-RING SEAL.
[9] Install a new O-RING SEAL.
[10] Install the DEVELOPER HEATER by reversing Steps 3 through 7 above.
Important
To prevent overtightening the 3 SCREWS and to prevent stripping the SCREW holes in the TANKS, follow the
recommendations below.
• Do not use power tools.
• First, partially tighten each of the 3 SCREWS.
• Then, tighten each of the 3 SCREWS securely.
[11] Fill the DEVELOPER TANK with water.
[12] Check for water leaks.
[13] Use the Service Routine to check for the correct operation of the DEVELOPER HEATER. See the Diagnostics
Manual, Publication Number 981093.
Removing the DEVELOPER HEATER
Figure 51
WASHER
(3)
SCREW
(3)
981090 – September 1995
DEVELOPER
TANK
O-RING
SEAL
DEVELOPER
HEATER
CONNECTOR P/J8
Plumbing
H130_0078BCA
H130_0078BA
61