SERVICE MANUAL
Repairing the DRYER RACK
Adjusting the DRYER RACK for Squareness
Adjusting the DRYER RACK for
Figure 24
Squareness
32
[1] Remove the DRYER RACK from the
PROCESSOR.
[2] Place the DRYER RACK on a flat work surface.
[3] Loosen the SCREWS on the ends of the 4 TIE
RODS.
[4] Loosen the SCREWS securing the TOP and
BOTTOM COVERS.
[5] Check that the 2 SIDEPLATES touch the flat
work surface evenly.
Dryer
[6] Twist the RACK as necessary.
Rack
[7] Tighten all the SCREWS.
[8] Install the DRYER RACK into the PROCESSOR.
H130_0199ACA
H130_0199AA
September 1995 – 981090