Racks; Repairing The Developer And Fixer Racks; Adjusting The Developer And Fixer Racks For Squareness - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL
Section 2: RACKS

Repairing the DEVELOPER and FIXER RACKS

Adjusting the DEVELOPER and FIXER RACKS for Squareness

Important
Only qualified service personnel should service the PROCESSOR.
Important
All the procedures in this section require that you de-energize the PROCESSOR and remove the TOP COVER before
beginning the first step of the service procedure.
Positioning the RACK
Figure 4
flat surface
10
RACK
SCREW
(4)
H130_0179ACA
H130_0179AA
[1] Remove the RACK from the PROCESSOR.
[2] Place the RACK on a smooth, flat surface.
[3] Loosen the SCREWS on the ends of the 4 TIE
RODS.
[4] Check that the 2 SIDEPLATES touch the flat
surface evenly.
[5] Twist the RACK as necessary.
[6] Tighten the SCREWS.
[7] Install the RACK into the PROCESSOR.
Adjusting the RACK for Squareness
Figure 5
SIDEPLATE
SIDEPLATE
TIE ROD (4)
H130_0104ACA
H130_0104AA
September 1995 – 981090