Repairing The Wash Rack; Adjusting The Wash Rack For Squareness - Kodak X-Omat M43 PROCESSOR Service Manual

Repairing the WASH RACK

Adjusting the WASH RACK for Squareness

Adjusting the WASH RACK
Figure 10
for Squareness
WASH
RACK
SIDEPLATE
WASH
MANIFOLD
981090 – September 1995
SIDEPLATE
TIE
ROD (2)
flat surface
SCREW (2)
H130_0144ACA
H130_0144AA
[1] Remove:
• DRYER RACK
• WASH RACK
[2] Place the WASH RACK on a smooth, flat surface.
Position the RACK so that the WASH
MANIFOLD hangs off the edge of the work
surface.
[3] Loosen the 2 SCREWS on the ends of the 2 TIE
RODS.
[4] Check that the 2 SIDEPLATES touch the flat
surface evenly.
[5] Twist the WASH RACK as necessary.
[6] Tighten the SCREWS loosened in Step 3.
[7] Install the WASH RACK and the DRYER RACK
into the PROCESSOR.
RACKS
17