Making The Plumbing Connections; Installing The Developer Filter; Connecting The Drains - Kodak X-Omat 5000 RA PROCESSOR Installation Instructions Manual

Hide thumbs Also See for X-Omat 5000 RA PROCESSOR:

Table of Contents

Making the Plumbing Connections

DEVELOPER

FILTER

CANISTER

H148_0021ACA

H148_0021AA

The PROCESSOR can drain developer, fixer, and water separately. The PROCESSOR is shipped with a separate

FIXER OVERFLOW/TANK DRAIN, AUXILIARY FIXER TANK DRAIN, DEVELOPER OVERFLOW/TANK DRAIN,

and AUXILIARY DEVELOPER TANK DRAIN.

Warning

• DRAINS must be made of chemically resistant, non-corrosive material. Use PVC or equivalent.

• The DRAIN must have a minimum diameter of 7.6 cm (3 in.) and be free of obstruction.

• Drain service must comply with all local codes.

• The HOSES must slope gradually down to the DRAIN.

• To prevent possible biological growth, do not allow the drain TUBES to touch the FLOOR DRAIN.

[1] Remove the three 1.9 cm (3/4 in.) HOSES from the PREPACK CARTON. Connect the 3 HOSES to the

DEVELOPER, FIXER, and WASH WATER DRAINS on the feed end of the PROCESSOR.

[2] Route the tubing as required to comply with local codes for disposing of wash water that contains photographic

chemicals. Do not make a solid connection between the WASH WATER DRAIN and the FLOOR DRAIN.

5B6339 – January 1996

FILTER

CAP

[1] Remove the FILTER CAP.

[2] Carefully place a new DEVELOPER FILTER into

the FILTER CANISTER.

[3] Install the FILTER CAP.

Connecting the PROCESSOR

Table of Contents